[Bell Historians] Plain bearings

[David Cawley]

I normally use a 3/4" cold chisel and a lump hammer. If theyre very corroded a drop of WD40 or some other penetrant along the leading edges of the brass will help.

DLC
----- Original Message ----- 
From: DJ Bryant 
To: bellhistorians at yahoogroups.com 
Sent: Friday, June 20, 2003 11:21 AM
Subject: [Bell Historians] Plain bearings


Anyone got any helpful tips on removing plain bearing brasses from cast
iron housings? Brute force, a hammer and a screwdriver generally seems
to result in a bent screwdriver!

David


Yahoo! Groups Sponsor 



This message was sent to you via the Bell Historians' Mailing List. To unsubscribe from the list send an email to bellhistorians-unsubscribe at yahoogroups.com



Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service. 



[Non-text portions of this message have been removed]